1963 CHEVROLET C10 CUSTOM PICKUP

Details

This custom 1963 Chevrolet C10 pickup is outfitted with a freshly built 383ci stroker engine created from a 4-bolt main block. The engine features long-tube Hooker headers, a CHF 40GPH electric water pump, Holley 15 psi fuel pump and bypass regulator. All braided AN fuel lines with AN filter. AN cooling lines with billet thermostat housing and water pump outlet. Additionally, the engine is fitted with COMP Cams tappet lifters and new pushrods, as well as a 303-duration camshaft with 303 intake

and 303 exhaust, 0.488 lift 144 lobe separation. The 383 also features a Weiand Warrior intake manifold and aluminum dual-core radiator. Billet distributor with 8mm wires and 6,500 rpm rev limiter, 6-quart oil pan, ARP Bolt set, and the entire engine has all new seals and gaskets and less than 60 miles since rebuild. Modern wiring and electronics have been used throughout the truck, and this custom features climate control. The pickup is equipped with air-ride suspension with two 5800 pumps, 7-gallon air reservoir, 10-inch air bags on all four corners connected by 0.375-inch air lines and a seven-switch controller.